Precautions When Using A Voltage Stabilizer (regulated Power Supply)

The following points should be noted when using Automatic Voltage Stabilizer:

1. Before installation, check whether the capacity and load of the voltage stabilizer (voltage stabilizer) are reasonably matched, whether the mains voltage is within the allowable range of the voltage stabilizer (voltage stabilizer), and whether the output voltage of the voltage stabilizer (voltage stabilizer) meets the equipment requirements;

2. The selection of the connection line of the voltage stabilizer (voltage stabilizer) must meet the requirements of the connection line that can carry sufficient current capacity;

3. When the power is turned on normally, do not disassemble the voltage stabilizer (voltage stabilizer) or pull the input and output connection lines of the voltage stabilizer (voltage stabilizer) at will to avoid electric shock or other electrical safety accidents;

4. The input and output connection lines of the voltage stabilizer (voltage stabilizer) must be arranged reasonably to avoid trampling and wear, which may cause safety accidents caused by leakage;

5. The grounding of the voltage stabilizer (voltage stabilizer) must be safe and reliable. Running the voltage stabilizer (voltage stabilizer) directly without grounding will cause personal injury such as electric shock;
6. The ground wire of the voltage stabilizer (voltage stabilizer) cannot be connected to public facilities such as heating pipes, water supply pipes, gas pipes, etc., so as not to infringe on the rights of third parties or cause other hazards;
7. Check the input and output connection wires of the voltage stabilizer (voltage stabilizer) regularly to avoid loosening and falling off, which will affect the normal use of the voltage stabilizer (voltage stabilizer) and electricity safety;
8. Remember to handle the voltage stabilizer (voltage stabilizer) with care, and avoid severe vibration during operation;
9. Ensure that the carbon brush spring of the voltage stabilizer (voltage stabilizer) has sufficient pressure to avoid sparking on the contact surface between the carbon brush and the coil;
10. Non-professionals please do not disassemble the voltage stabilizer (voltage stabilizer) or repair the voltage stabilizer (voltage stabilizer) without permission;
11. Operate strictly in accordance with the operating instructions of the voltage stabilizer.
Mastering the safe use of voltage stabilizers (voltage stabilized power supplies) can not only reduce the occurrence of safety accidents, but also effectively save the maintenance costs caused by equipment damage caused by improper user operation. Of course, in addition to paying attention to the above content when using, you must also choose voltage stabilizers (voltage stabilized power supplies) produced and sold by regular manufacturers, whether it is quality, after-sales or service,