Ups Startup And Configuration

Before starting up, make sure the battery switch is disconnected and the main power switch is off. First, supply AC power to the Uninterruptible Power Supply(UPS) to put it in bypass mode. Then turn on the loads one by one, paying attention to turning on the loads with larger inrush current first, and then the loads with smaller inrush current.
After the UPS power is turned on, it will perform a self-test process. At this time, please do not turn off the UPS power or unplug the power plug to avoid affecting the self-test results.
Configure the UPS according to the manual, including setting parameters such as battery capacity, delay time, and output voltage.